DOWNLOAD / ACTIVATE / CONFIGURE

Your first flash
starts here.

Prepare your vehicle, PC and interface before purchasing or programming. Follow the workflow for your chosen package.

Before you connect.

  • Supported BMW E60 M5 or E63/E64 M6 configuration
  • PC running 64-bit Windows 10 or 11
  • High-quality K+DCAN interface with EdiabasLib firmware
  • Stable vehicle power throughout programming
  • Your original DME files retained safely

Installing Ultra?

Confirm your complete hardware setup and installer capability before purchase. DCT conversion wiring, mechanical work and routine vehicle coding require an experienced installer.

Review Ultra support scope →

M-SHIFT TUNING STUDIO

One place to
configure your car.

Windows installer · Version 17.3.25

Basic is free. Premium and Ultra require their respective VIN-bound licences. The installer is unsigned, so Windows may show an unknown-publisher warning.

Keeping Studio up to date.

Studio checks for newer releases when opened with internet access. You can also select Check for Updates. Updates are not installed automatically.

Ultra includes Ultra-specific tools within M-Shift Studio for custom-firmware functions. Some INPA and ISTA functions are not supported by that firmware.

THE WORKFLOW

Prepare. Activate. Configure.

Check your setup.

Confirm your vehicle, hardware and package. You’ll need a compatible K+DCAN interface, stable vehicle power and 64-bit Windows 10 or 11.

Install M-Shift Studio.

Download the Windows installer. Basic tools are free. Premium and Ultra require their respective licences.

Activate and follow the workflow.

Identify your connected DME and activate with your PayPal purchase email. For stock DME tuning, retain the original read before preparing and flashing your calibration.

Premium and Ultra activation

After payment is confirmed, identify the connected DME in Studio, open Licence Activation, enter your PayPal purchase email and select Premium or Ultra. VIN assignment happens on connection. If you have multiple licences, select the appropriate available credit for the vehicle.

Stock DME calibration

Read and retain the original DME file. Select supported changes, prepare your calibration and follow the Studio flashing workflow. Keep stable power and the compatible interface connected throughout.

Ultra firmware: installation and removal

Installation takes approximately 20 minutes. To remove the custom firmware, you must use M-Shift Studio. Do not overwrite it directly with standard DME firmware: this risks bricking the DME.

BEFORE YOUR FIRST WRITE

Follow the workflow for your module.

Switch the ignition on, keep headlights and HVAC off, and maintain stable vehicle power. Use a high-quality K+DCAN cable with EdiabasLib firmware and select the correct COM port in Studio.

DME tune reading and full backups are different operations. SMG III uses a supplied calibration base and does not offer the same flash-memory reading workflow.

Open the Studio guide →